Satellite TV at Sea

Satellite TV Antennas

In order to receive Satellite TV at Sea you will need a Maritime Stabilized Satellite TV Antenna. This antenna will point to the satellite regardless of the movements of the ship it is on and will do this very accurately. Keep in mind that the satellite is at approximately 35.000 km distance. So you could compare it to shooting through a keyhole with a laserpointer while sitting on a mechanical bull. Not easy if you have to do this manually.

Antenna Size

Usually the size of the antenna is determined by the size of the ship it will be installed on. Larger ships will have larger antennas and smaller ships smaller. This is mostly due to space and budget but can have aesthetic reasons as well.

Larger antennas receive more signal and will allow you to watch TV in more remote areas or in worse weather conditions than the smaller versions. You should therefore always try to get the largest possible antenna on your ship. More information on Antenna Size

Circular or Linear Polarization

Satellite Signal Polarization

Satellite TV signals are transmitted orthogonally, which means that from the satellite signals are sent horizontally/vertically. This is usually the case outside in EMEA and Asia. They can also be circular, which means the signal rotates with or counter clockwise. This is more common in the US.

When selecting an antenna for reception of orthogonal signals (horizontal or vertically polarized) then the angle of the of the satellite receiver will become very important. If the skew angle is incorrectly set, which depends your position and the selected satellite, your TV signal will be poor. A 10° error can already make the difference between a good image and no image. More about this when talking about the choice of 2 or 3 axis antennas.

First of all the polarity is important to choose the right LNB (Low Noise Block Down Converter - the receiver). Depending on the region you will sail in you will select either Orthogonal or Circular polarization. For larger vessels who frequenctly need to switch from Circular polarization to Orthogonal you should consider an antenna with the ability to switch between both (Intellian t110W and t130W)

2-Axis or 3-Axis antennas

2-Axis antennas are for ships that don't move heavily (rivers, lakes, in harbour, calm sea, ...). The antenna will move around its azimuth (yaw) and elevation (pitch) axis and will usually have a manual or automatic skew adjustment.

So why would you need a 3 axis antenna.

Skew Adjustment

In a 2-axis antenna your skew angle will not move along with the roll or pitch of your ship. If this becomes big (remember the 10° angle when we talked about Orthogonal polarization) then your receiver will not be well aligned with the satellite signal and you will have permanent or intermittent less than optimal signal reception.

If you are going to watch TV at sea during heavy sea then it is recommended to choose a 3-axis antenna which will be able to receive a stronger signal than its same size 2-axis counterpart because of the use of the 3rd cross (roll) axis.

Skew adjustment = ability to adjust the receiver to your geographic location so that the receiver is set parallel to the signal. This only changes when your location changes (by more than tens of kilometers)

Beware: Some manufacturers will advertise 2-axis antennas with automatic skew as a 3-axis antennas. This is not the same as 'real' 3-axis antennas which should then be called 4-Axis (yaw, pitch, roll AND skew)

Total amount of TVs/Decoders

Depending on the amount of TV sets you will have on board you need to keep in mind that the satellite signal will need to be distributed to all the set top boxes/decoders. Smaller antenna models usually have a QUAD LNB with a maximum of 2 to 4 connections.

If you require more connections then you will need an antenna with a QUATTRO LNB connected to a multiswitch. The multiswitches will then distribute the TV signal to all the locations on board the ship.

If your ship requires a large amount of TVs then you will require a DVB-C or IP Head-End solution to distribute the TV signal to all the TVs. Head End solutions become valuable when distributing paid content (subscrption channels, Sports, Movies) which will in a regular scenario require a subscription for each individual TV

... more information on Digital Head Ends

2 Axis Antennas for TV

3 Axis Antennas for TV